How to Wear and Tie an Alter Bridge Bandana: 5 Practical Styles
By Revolver Magazine Online Store | Heavy Metal Merch | Published: 2026-11-05
Category: Poradniki
Learn five practical ways to tie a bandana for concerts, festivals, and daily wear, plus how to style the Alter Bridge Tour of Horrors bandana without damaging its artwork.
Quick answer
Fold the bandana into a triangle, roll the long edge to your preferred width, and tie it where you want the visual weight—head, neck, wrist, or bag. For the Alter Bridge Tour of Horrors bandana, keep the printed side facing out and avoid tying directly over the artwork to protect it.
Choose a fold that protects the print
The Alter Bridge Tour of Horrors bandana features original artwork by Brian Level and Dan Brown, so the fold you choose affects both look and longevity. A simple triangle fold puts the artwork front and center, while a rolled band creates a narrower stripe that can hide parts of the design. If you want to show the full print, wear it as a neckerchief with the triangle point at the front. For a headband, roll from the long edge so the artwork sits across the forehead rather than being crushed into the knot.
Match the tie to the setting
A loose neckerchief works for casual days and indoor shows, but it can slip during energetic sets. A snug headband stays put in a crowd but may feel tight under a hat. For festival outfits, a wrist tie adds color without covering your face or hair. There is no single right style—test each tie at home before a concert so you know how it behaves when you move.
5 ways to tie your bandana
- Classic neckerchief: Fold the bandana in half diagonally to form a triangle. Roll the long edge down two or three times to create a band, then wrap it around your neck with the triangle point at the front and tie a single knot at the back. Common mistake: tying too tight and stretching the fabric—leave room to slip two fingers under the band. Check the knot sits flat and the point hangs evenly before you head out.
- Headband: Fold the bandana into a triangle, then roll from the long edge toward the point until you have a strip about 2–3 inches wide. Place the center of the strip at the nape of your neck, bring the ends up over your ears, and tie at the top of your head. Common mistake: rolling too loosely so the bandana slides down—roll tightly and test by shaking your head. If you have thick hair, use a second knot or tuck the ends under the band for extra hold.
- Wrist wrap: Lay the bandana flat and fold it into a narrow strip about 2 inches wide. Wrap it around your wrist twice, then tie a small double knot on the inside of your wrist. Common mistake: tying over the printed artwork, which can cause friction and fading—keep the knot on the plain back side. Trim any long ends or tuck them under the wrap to avoid catching on gear.
- Bag or belt loop accent: Fold the bandana into a triangle and roll it into a strip. Thread it through a belt loop or bag strap, then tie a simple knot and let the ends hang. Common mistake: letting the bandana drag on the ground—adjust the length so it sits above knee height. Use a double knot on bags that swing a lot so the bandana stays put.
- Festival-ready head wrap: Fold the bandana into a triangle and place the long edge across your forehead, with the point at the back of your head. Tie the ends at the nape of your neck, then tuck the point under the knot. Common mistake: covering your ears too tightly, which can muffle sound—keep the band above your ears. This style works well under a hat; test the fit with your hat on before the event.
Product facts
- ALTER BRIDGE: TOUR OF HORRORS - BANDANA: The Alter Bridge: Tour of Horrors bandana features original artwork by Brian Level and Dan Brown. The detailed print is the focal point, so choose a tie that keeps the design visible and avoid sharp creases through the artwork.

ALTER BRIDGE: TOUR OF HORRORS - BANDANA
